Sunday, December 29, 2019

Water Heater Richardson TX

https://www.facebook.com/WaterHeaterRichardsonTX/

Water Heater Richardson TX

Part 1

Attach a pipe to the drain valve
1- If you have an electric water heater, turn off the gas.
2- If you have a gas water heater, turn the pilot light switch to "Pilot."
3- Turn off at the top of the water heater the water supply valve.
4- Attach a garden hose at the bottom of the tank to the drain valve.
5- Place outside the other end of the hose below the drain level.

Part 2

The drain valve is closed
1- Turn the knob to open the drain valve.
2- To open it, pull up the pressure relief valve at the top of the tank.
3- Allow the entire water to drain.
4- For 5 minutes, open the water valve to flush out the water heater.

Part 3

Replace the water heater
1- Open the intake valve and the exhaust valve.
2- Disconnect from the drain valve the garden hose.
3- Flip the disconnector to turn back on the power.
4- If it is a gas water heater, turn the pilot light to the "Off" position.

(972) 674-8261

Location Services :
 
 

Tuesday, October 15, 2019

Water Heater Richardson TX

+Water Heater Richardson TX ❤️👋
{How To [Reset] a Water Heater}

The water heater reset button is the red button located on the water heater itself (just above the thermostat). Some water heaters may have two reset buttons-one for each thermostat. To access the reset button, you may have to remove the metal plate covering the thermostat that's held in place by screws.

https://waterheaterrichardsontx.com/
Phone: (972) 674-8261 📞


water_heating
electrical_water_heater
plumbers_near_me
hot_water_heater
electric_water_heater  

plumbing_services
emergency_plumber
water_heater_repair
Water_heater_installation
commercial_plumber
residential_plumber
commercial_plumbing
Water_Heater_Richardson_TX
Plumbing_Richardson_TX